Messages. 1. Points. 1. Apr 11, 2021. #1. Hi, just bought the mk3 panda, rear washer jet is not working, is it part of the third brake light, and if so does anyone know which way the hose runs through the car. The motor is working and the front washer jets are working too, so I suspect the jet or a pipe or a blockage some where. Another common problem that Fiat Panda users have reported is transmission issues. Common transmission problems are problems changing gears and clutch juddering as you try to change gears. If you have a problem changing gears, this is a sign of a gear selector issue. On the contrary, clutch juddering is caused by a worn-out gear linkage. BGood morning, Long time no post (6-7 years since the last time!!) I'm wondering if any one can help me please. I have fiat panda active eco 1.1 2010. 2 years ago I got a problem, when I put my foot on the break, while indicating, the internal light and clicker for the indicators would go at K. i’ve got a fiat ducato 1998 19TD my wipers stopped working, thought it was the motor stripped it down it was the mechanism had seized up, i would spray all that with WD40, if you can get the motor off just check that on it own too, if you can get to the nut that connects the mechanism to the motor maybe just undo that then try your motor If the Fiat Panda wipers do not work, check that their fuse is intact. The problem could also be caused by a defect in the mechanism or damage to the wiring. Posted on: 11 March 2022 by Scegli Auto Its a 2013 Fiat 500 sport manual. I'm 6'2" 275lbs and fit in it great. Regretfully the front and rear windshield wipers do not work. Checked both fuse boxes and there all good. The trip button does not work either that is on the end of the wiper stalk. Im assuming the switch unit that has both stalks on it is bad. k2Xl. Hey all, my wipers have well and truely had it so looking for some decent replacements. Car is an 07 100HP Can anyone recommend any? Especially rear wipers as can't seem to find out which I should be buying. Many thanks, Wayne. Jun 26, 2012. #2. i went for using a glue gun to glue it on. just got to get it straight so the clip sits under the splines. and i can heat up again to get it off if i need too. has stayed on for a few weeks now.. although now i've tempted fate. S. Surrey. Dec 1, 2015. #3. This happened on my 08 Fiat 500, it turned out the passenger wiper was too high. If you look on the edges of the wipers you'll see three dots on the window and this is where the wipers need to be. I think it was a 13mm spanner to undo the wiper and moving it down, not had any trouble with mine since. Can anyone tell me why it seems like all Fiat windscreen wipers squeal like a pig being electrified even though the screen is wet? The ones on my Panda do it and I used to have a Tempra which did the same. :bang::bang::bang::bang::bang: For post 2012 Panda -. - Remove the pull-off panels in front of each wiper spindle (pull from the right hand side of each one as that side unclips. Also note the small round drain hole at the right side of the 'recess' the covers fit over - see second photo) - Remove the wiper arms (first remove plastic cap from nut, then unscrew nut and lift Turn off front wipers before engaging reverse, Contact Fiat and get the 'computer' updated if possible. Remove fuse from rear wiper - would totally immobilse it. Fit another switch onto the rear wiper circuit. Remove reverse gear selection switch. 3,4, and 5 are more work / consequences.

fiat panda wipers not working